Service Program Mode; General Notes; Service Mode Lock/Unlock; To Enter And Exit The Service Program Mode - Ricoh D065 Service Manual

Hide thumbs Also See for D065:

Table of Contents

5. SYSTEM MAINTENANCE

5.1 SERVICE PROGRAM MODE

The service program (SP) mode is used to check electrical data, change modes, and

adjust values.

Never turn off the main power switch when the power LED is lit or flashing. To

avoid damaging the hard disk or memory, press the operation power switch to

switch the power off, wait for the power LED to go off, and then switch the main

power switch off.

At locations where the machine contains sensitive data, the customer engineer cannot

operate the machine until the Administrator turns the service mode lock off. This function

makes sure that work on the machine is always done with the permission of the

Administrator.

If you cannot go into the SP mode, ask the Administrator to log in with the User Tool

and then set "Service Mode Lock" to OFF. After he or she logs in:

User Tools > System Settings > Administrator Tools > Service Mode Lock > OFF

This unlocks the machine and lets you get access to all the SP codes.

The CE can do servicing on the machine and turn the machine off and on. It is not

necessary to ask the Administrator to log in again each time the machine is turned

If you must use the printer bit switches, go into the SP mode and set SP 5169 to "1".

After machine servicing is completed:

Change SP 5169 from "1" to "0".

Turn the machine off and on. Tell the administrator that you completed servicing

the machine.

The Administrator will then set the "Service Mode Lock" to ON.

Ask your supervisor how to enter and/or exit the service program mode.

Service Program Mode

D062/D063/D065/D066

Table of Contents