Lift Motor
Note: Use this procedure for removal of Tray 3, Tray 4, and Tray 5 Lift Motors.
Removal
1.
Remove the Paper Tray (3 ~ 5) from the Paper Feeder (3 ~ 5).
2.
Remove the HCF Rear Cover.
3.
Disconnect the P/J that is attached to the Lift Motor.
4.
Remove the three long screws securing the Motor to the HCF frame.
5.
Slide the Motor out to remove it.
Replacement
1.
Remove the Paper Tray (3 ~ 5) from the Paper Feeder (3 ~ 5).
2.
Remove the HCF Rear Cover.
3.
Reinstall the Lift Motor onto the printer frame. Be careful not to trap any wires
between the Motor and the frame.
4.
Use three long screws to secure the Motor to the frame. Use one screw on the lower
left and two screws on the right side of the Motor.
5.
Reconnect the P/J to the rear of the Motor.
6.
Reinstall the HCF Rear Cover.
7.
Reinstall the Paper Tray.
4025 Options
4-67
Repair Information