Lexmark W820 Service Manual page 222

Replacement
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
4-80
Service Manual
Hold down the Stopper Link while you insert the end of the Feed Shaft into the
opening in the rear of the HCF frame.
Slide the Bearing into the Bearing cutout (refer to the figure).
When both the Bearing is in place and the end of the Feed Shaft is through the
opening in the rear of the frame, release the Stopper Link. The Nudger Shaft should
rest on top of the Stopper Link, and the Link should secure the Feeder Assembly in
place on the frame.
Make sure the Paper Level Actuator tab on the Feeder is positioned in the center of
the arms of the Paper Level Sensor.
Slide the Feed Bearing onto the Feed Shaft and press the Bearing into the cutout in
the frame.
Reinstall the Feed Gear onto the Feed Shaft, and use an E-ring to secure it to the
Shaft.
Reinstall Tray 3 Feed Clutch.
Lift the Retard Shaft up and out of the way while you slide the Feed In Chute under
the Retard Assembly and against the HCF frame.
Slide the Chute to the rear of the HCF so the rear of the Chute hooks on to the
frame, and the screw hole at the front of the Chute aligns with the screw hole in the
HCF frame.
Use one screw to secure the Feed In Chute to the HCF frame.
Reinstall the Inner Chute onto the HCF frame.
Use two screws to secure the Inner Chute.
Reinstall the Spring to the left side of the Inner Chute.
Reinstall the Rear Cover.
Reinstall Tray 3.
4025 Options