Duplex Wait Sensor - Lexmark W820 Service Manual

Duplex Wait Sensor

Removal
1.
2.
3.
4.
5.
Replacement
1.
2.
3.
4.
5.
6.
4-14
Service Manual
Remove the Duplex Cover.
Remove the screw securing the Wait Sensor Bracket to the Duplex frame.
Remove the Bracket and the attached Wait Sensor.
Disconnect P/J 123 from the Sensor.
Squeeze the four latches securing the Sensor to the bracket and remove the Sensor.
Position the Sensor on the Bracket so the Sensor latches match the openings in the
Bracket.
Press the four latches on the bottom of the Sensor into the four openings in the
Bracket. The Sensor snaps into place.
Reconnect P/J 123 to the Sensor.
Slide the Sensor actuator through the slot in the Duplex Unit, and slide the two arms
of the Sensor Bracket under the two tabs next to the actuator slot.
Use one screw to secure the Bracket to the Duplex Unit.
Reinstall the Duplex Cover.
4025 Options