Lexmark W820 Service Manual page 214

Note: Use this procedure for removing and replacing the No Paper Actuator for Trays 3,
4, and 5.
Removal
1.
2.
3.
4.
Replacement
1.
2.
3.
4.
5.
6.
4-72
Service Manual
Remove the Paper Tray associated with the No Paper Actuator you are going to
remove.
Remove the No Paper Sensor associated with the No Paper Actuator you are going
to remove.
Squeeze together the sides of the Actuator Bracket and remove the Actuator Bracket
from the HCF frame.
Press the Actuator out of the Bracket.
Press the legs of the Actuator into the slots on the Bracket. The Actuator snaps into
place.
Reinstall the Bracket into the opening in the HCF frame by positioning the Bracket so
the Actuator paddle faces the front of the printer.
Insert the left side of the Bracket into the opening, then squeeze together the sides
of the Bracket while inserting the right side into the opening.
Release the Bracket and it should snap into place and secure the Bracket to the
frame.
Reinstall the No Paper Sensor.
Reinstall the Paper Tray.
4025 Options