Exit Roll Belt - Lexmark W820 Service Manual

Exit Roll Belt

Removal
1.
2.
3.
4.
5.
6.
Replacement
1.
2.
3.
4.
5.
6.
7.
4-16
Service Manual
Remove the Duplex PWB Bracket.
Remove the Duplex Drive Assembly.
Remove the two screws securing the Exit Gate Solenoid Bracket to the frame and
remove the Bracket and Solenoid.
Remove the E-ring from the #1 Transport Roll Drive Gear, and slide the Gear off of
the shaft.
Remove the E-ring from the Friction Clutch, and slide the Clutch off of the shaft.
Slide the Exit Roll Pulley off of the shaft and remove the Exit Roll Belt.
Reinstall one end of the Exit Roll Belt over the small end of the Exit Roll Pulley.
Slide the Exit Roll Pulley onto the Exit Roll shaft.
Slide the Friction Clutch onto the shaft and use an E-ring to secure it to the shaft.
Slide the #1 Transport Roll Drive Gear onto the Transport Roll shaft and use an E-
ring to secure it to the shaft.
Reinstall the Exit Gate Solenoid Assembly and Bracket onto the frame, and use two
screws to secure the Bracket.
Reinstall the Duplex Drive Assembly.
Reinstall the Duplex PWB Bracket.
4025 Options