Duplex Exit Gate Solenoid - Lexmark W820 Service Manual

Duplex Exit Gate Solenoid

Removal
1.
Remove the Duplex Cover.
2.
Remove the Duplex Rear Cover.
3.
Disconnect P/J 222 from the Duplex PWB.
4.
Remove the wire harnesses from the wire clip that is mounted on the Solenoid
Bracket.
5.
Remove the two screws securing the Duplex Exit Gate Solenoid Bracket to the
Duplex frame, and remove the Bracket and attached Solenoid.
6.
Remove the two screws securing the Duplex Exit Gate Solenoid from the Bracket,
and remove the Solenoid.
Replacement
1.
Reinstall the Duplex Exit Gate Solenoid onto the Bracket.
2.
Line up the two screw holes in the Bracket with the two screw holes in the Solenoid,
and use two short screws to secure the Solenoid to the Bracket.
3.
Make sure the Exit Gate Link is in place.
4.
Rotate the Solenoid plunger so the fork in the Link slips through the slot in the
plunger.
5.
Press the Solenoid Bracket against the Duplex frame.
6.
Use two screws to secure the Bracket to the frame.
7.
Lift and release the Solenoid plunger to make sure it opens the Link correctly.
8.
Reconnect P/J 222 to the Duplex PWB.
9.
Reroute the wire harness through the wire clip located on the Solenoid Bracket.
10.
Reinstall the Duplex Rear Cover.
11.
Reinstall the Duplex Cover.
4025 Options
4-11
Repair Information