Lexmark W820 Service Manual page 224

Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
4-82
Service Manual
Remove Tray 3 from the HCF.
Remove the Rear Cover.
Remove the HCF Left Cover.
Open the Left Cover Assembly.
Remove the Spring that is located on the left side of the Inner Chute (Figure 1).
Remove the two screws securing the Inner Chute to the HCF frame, and remove the
Inner Chute.
Pull the plastic Upper Take Away Chute off of the Bearings, and remove the Chute.
Remove the screw securing the Feed In Chute to the HCF frame.
Lift the Retard Shaft up and out of the way while you slide the Feed In Chute to the
front of the HCF. Sliding the Feed In Chute to the front unhooks the Chute from the
HCF frame.
Push the Chute back and remove it from the frame.
Disconnect P/J 211 from Tray 3 Feed Clutch.
Disconnect J211 and J213 from the Bracket (Figure 2), and free the wire harness
from the harness clips.
Remove the two screws securing the Bracket to the HCF frame, and remove the
Bracket.
Remove Tray 3 Feed Clutch.
Remove the E-ring securing the Drive Transmission Gear to the shaft and remove
the Gear.
Remove the E-ring securing the Take Away Gear to the shaft and remove the Gear.
Remove the E-ring securing the Fixed Gear to the shaft and remove the Gear.
Slide the Retard Gear off of the shaft.
Slide the Take Away Bearing off of the shaft.
Slide the Retard Assembly to the front of the HCF, and then swing the rear of the
Assembly out of the HCF.
4025 Options