Tray 3 Take Away Sensor - Lexmark W820 Service Manual

Tray 3 Take Away Sensor

Removal
1.
2.
3.
4.
5.
6.
Replacement
1.
2.
3.
4.
5.
6.
7.
8.
4-78
Service Manual
Open the Left Cover Assembly.
Remove the Spring that is located on the left side of the Inner Chute.
Remove the two screws securing the Inner Chute to the HCF frame, and remove the
Inner Chute.
Squeeze the four latches that are located at the four corners of the Sensor, while
pulling the Sensor forward.
Remove the Sensor from the HCF frame.
Disconnect P/J 121 from the Sensor.
Reconnect P/J 121 to the Sensor.
Position the Sensor with the positioning tab facing down.
Insert the Sensor into the opening in the HCF frame.
Press the Sensor into the opening unit it snaps into place.
Reinstall the Inner Chute onto the HCF frame.
Use two screws to secure the Inner Chute.
Reinstall the Spring to the left side of the Inner Chute.
Close the Left Cover Assembly.
4025 Options