Lexmark W820 Service Manual page 173

Removal
1.
Remove the Paper Stopper.
2.
Remove the Actuator Cover Assembly.
3.
Remove the screw securing the LED and the LED Cover to the BIN 10 Tray
Assembly, and remove the LED and LED Cover (Inset 1).
4.
Slip the Drive Belt off of BIN 10 Drive Pulley.
5.
Remove the three screws securing BIN 10 Tray to the Mailbox frame.
6.
Pull out on latch arms to release the latch that is securing BIN 10 Tray Assembly to
BIN 9 Gate (Inset 2) and remove BIN 10 Tray Assembly.
Replacement
1.
Reinstall BIN 10 Tray onto the Mailbox frame. Make sure the tabs on the Tray line up
with the slots in the frame.
2.
Open the Mailbox Chute so you can access BIN 9 Gate.
3.
Hold on to BIN 9 Gate while you press down on the Tray Assembly so the latch arms
on the Tray Assembly latch onto BIN 9 Gate.
4.
Use three screws to secure BIN 10 Tray to the Mailbox frame.
5.
Slip the Drive Belt onto BIN 10 Drive Pulley.
6.
Reinstall the LED and the LED Cover, and use one screw to secure them to the BIN
10 Tray Assembly.
7.
Reinstall the Actuator Cover Assembly.
8.
Reinstall the Paper Stopper.
4025 Options
4-31
Repair Information