High Capacity Feeder; High Capacity Feeder Error Code Table - Lexmark W820 Service Manual

High Capacity Feeder

High Capacity Feeder Error Code Table

This table lists all of the High Capacity Feeder Error Codes that are generated by the
printer Engine Board (MCU PWB).
Depending on the level of firmware on your printer Engine Board (MCU PWB) some
codes listed may be invalid, some codes generated by the MCU may not appear in this
table, and Error and Message Code text presented may differ slightly from the Error and
Message Code text that is actually generated by your MCU.
Error Code
245
246
248
249
250
251
252
261
253
2-32
Service Manual
4025 Options
Description
Logic Control on the MCU PWB sensed that the Tray 2 Take Away Sensor did
not actuate within the specified time after the Tray 3 Feed Clutch was actuated.
Go to "Error Code 245" on page
Logic Control on the MCU PWB sensed that when paper was fed from Tray 3,
the Registration Sensor did not actuate within the specified time after the Tray 2
Take Away Sensor actuated. Go to
Logic Control on the MCU PWB sensed that when paper was fed from Tray 4,
the Tray 3 Take Away Sensor did not actuate within the specified time after the
Tray 4 Feed Clutch was actuated. Go to
Logic Control on the MCU PWB sensed that when paper was fed from Tray 4,
the Tray 2 Take Away Sensor did not actuate within the specified time after the
Tray 3 Take Away Sensor was actuated. Go to
page 2-38.
Logic Control on the MCU PWB sensed that when paper was fed from Tray 4,
the Registration Sensor did not actuate within the specified time after the Tray 2
Take Away Sensor was actuated. Go to
Logic Control on the MCU PWB sensed that when paper was fed from Tray 5,
the Tray 4 Take Away Sensor did not actuate within the specified time after the
Tray 5 Feed Clutch was actuated. Go to
Logic Control on the MCU PWB sensed that when paper was fed from Tray 5,
the Tray 3 Take Away Sensor did not actuate within the specified time after the
Tray 4 Take Away Sensor was actuated. Go to
page 2-42.
Logic Control on the MCU PWB sensed that when paper was fed from Tray 5,
the Tray 2 Take Away Sensor signal did not actuate within the specified time
after the Tray 3 Take Away Sensor was actuated. Go to
page 2-47.
Logic Control on the MCU PWB sensed that when paper was fed from Tray 5,
the Registration Sensor did not actuate within the specified time after the Tray 2
Take Away Sensor was actuated. Go to
2-33.
"Error Code 246" on page
"Error Code 248" on page
"Error Code 249" on
"Error Code 250" on page
"Error Code 251" on page
"Error Code 252" on
"Error Code 261" on
"Error Code 253" on page
2-35.
2-36.
2-39.
2-41.
2-44.