Lexmark W820 Service Manual page 170

Removal
1.
2.
3.
4.
5.
Replacement
1.
2.
3.
4.
5.
6.
4-28
Service Manual
Remove the Mailbox Top Cover Assembly.
Disconnect P/J 820 from the Bin 10 Jam Sensor.
Disconnect P/J 823 running to the Vertical Sensor.
Pull all of the wires free of the wire clips at the top of the Actuator cover.
Remove the three screws securing the Actuator Cover Assembly to the frame, lift the
Cover free of the wire harness and remove it from the Mailbox.
Position the Actuator Cover Assembly over the top of the Mailbox.
Reach under the Actuator Cover and pull the Full Stack Actuator 2 up and out of the
way.
Reinstall The Actuator Cover Assembly onto the Mailbox.
Use three screws to secure the Actuator Cover to the Mailbox.
Reinstall the wire harness under the wire clips located on the side of the Actuator
Cover and reconnect the Bin 10 Jam Sensor P/J.
Reinstall the Mailbox Top Cover Assembly.
4025 Options