Lexmark W820 Service Manual page 177

Note: This Removal and Replacement procedure describes the removal and
replacement of a single BIN Tray, from BIN 9 through BIN 1. When removing a BIN Tray
start by removing BIN Tray 10, then remove BIN Tray 9. Remove the BIN Trays
sequentially, 9 through 1, by repeating the steps in this procedure for each remaining
Tray.
Removal
1.
Remove the wire Paper Stopper attached to Bins 1 and 10.
2.
Remove the Actuator Cover Assembly.
3.
Remove BIN 10 Tray Assembly.
4.
Remove Gate 9 Solenoid.
5.
Remove the three screws securing BIN 9 Tray to the Mailbox frame.
6.
Pull out on latch arms to release the latch that is securing BIN 9 Tray Assembly to
BIN 8 Gate and remove Bin 9 Tray Assembly.
7.
Slide Bin 9 Drive Pulley out of the Drive Belt and remove BIN 9 Tray Assembly.
Replacement
1.
Reinstall BIN 9 Tray onto the Mailbox frame. Make sure the tabs on the Tray line up
with the slots in the frame.
2.
Open the Mailbox Chute so you can access BIN 8 Gate.
3.
Hold on to BIN 8 Gate while you press down on the Tray Assembly so the latch arms
on the Tray Assembly latch onto BIN 8 Gate.
4.
Use three screws to secure BIN 9 Tray to the Mailbox frame.
5.
Slip the Drive Belt onto BIN 9 Drive Pulley.
6.
Reinstall Gate 9 Solenoid.
7.
Reinstall BIN 10 Tray Assembly.
8.
Reinstall the Actuator Cover Assembly.
9.
Reinstall the wire Paper Stopper to Bins 1 and 10.
4025 Options
4-35
Repair Information