Lexmark W820 Service Manual page 205

Removal
1.
Remove the HCF Rear Cover.
2.
Disconnect P/J217 from the HCF PWB.
3.
Hold on to the rear of the Feed Motor while you remove the two screws securing the
Motor Bracket to the frame (Figure 1).
4.
Slide the Feed Motor out of the HCF Drive Belt and remove the Motor from the
frame.
Replacement
1.
Position the Feed Motor so the wire harness is on the left side of the Motor
(Figure 1).
2.
Reinstall the Motor and slip the Drive Belt over the Feed Motor Gear.
3.
Align the Motor Bracket with the frame positioning tabs.
4.
Use two screws to secure the Motor Bracket to the frame, but do not tighten fully.
5.
Tighten the Drive Belt tension by pushing the Motor Bracket in the direction of the
arrow (Figure 2) and fully tightening the two screws securing the Bracket to the
frame.
6.
Reconnect P/J217 to the HCF PWB.
7.
Reinstall the Rear Cover.
4025 Options
4-63
Repair Information