Tray 3 Feeder Assembly - Lexmark W820 Service Manual

Tray 3 Feeder Assembly

WARNING: Take care not to break or dislodge the No Paper Actuator when removing or
replacing the Tray 3 Feeder Assembly.
Removal
1.
Remove Tray 3 from the HCF.
2.
Remove the Rear Cover.
3.
Open the Left Cover Assembly.
4.
Remove the Spring that is located on the left side of the Inner Chute.
5.
Remove the two screws securing the Inner Chute to the HCF frame, and remove the
Inner Chute.
6.
Remove the screw securing the Feed In Chute to the HCF frame.
7.
Lift the Retard Shaft up and out of the way while you slide the Feed In Chute to the
front of the HCF. Slide the Feed In Chute to the front to unhook the Chute from the
HCF frame.
8.
Push the Chute back and remove it from the frame.
9.
Remove Tray 3 Feed Clutch.
10.
Remove the E-ring that secures the Feed Gear (located behind the Feed Clutch) to
the shaft, and remove the Feed Gear and Bearing.
11.
Hold down the Stopper Link while you pull the Feeder Assembly to the front of the
HCF frame.
12.
Remove the Feeder Assembly from Feeder 3.
4025 Options
4-79
Repair Information