Lexmark W820 Service Manual page 232

Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
4-90
Service Manual
Slide out Tray 5.
Remove the Rear Cover.
Remove the HCF Left Cover.
Open the Left Cover Assembly.
Remove the Spring that is located on the left side of the Inner Chute (Figure 1).
Remove the two screws securing the Inner Chute to the HCF frame, and remove the
Inner Chute.
Disconnect P/J 211 from Tray 3 Feed Clutch.
Disconnect J211 and J213 from the Bracket (Figure 2), and free the wire harness
from the harness clips.
Remove the two screws securing the Bracket to the HCF frame, and remove the
Bracket.
Remove the E-ring securing Gear 22 to the Take Away Roll shaft (Figure 3).
Hold on to Gear 22 as you slide Tray 4 Take Away Roll toward the front of the HCF.
Remove Gear 22 and the Bearing.
Remove Tray 4 Take Away Roll.
4025 Options