Table of Contents
Advertisement
STEP 5
a) Remove the ALUMINUM BEAM [001] from the Carton and place it on top of the Carton Lid as shown
in the diagram below.
b) Remove 4 x BOLT [300] from ALUMINUM BEAM [001] and 2 x BOLT [302] from REAR
STABILIZER [006] with the TOOL provided.
c) Assemble REAR STABILIZER [006] with the same 4 x BOLT [300] and tighten firmly.
d) Assemble ALUMINUM BEAM END CAP [116] with 2 x BOLT [302] and tighten firmly.
e) Remove the Twist Tie and discard.
STEP 6
a) Remove 8 x BOLT [300] from DIE CAST PIVOT [003] with the TOOL provided.
b) Assemble the ALUMINUM BEAM [001] with the same 8 x BOLT [300] and tighten firmly.
40
Advertisement
Table of Contents
