Configuring Features - GE NX-10 Installation Manual

The keypad beeps once to accept the change and returns to Outputs.
8.
Table 9. NX-320-I output events
# Event
Alarms
17 Alarm Memory
Tests
3 Dyn Battery Test
Tampers
25 Fire LED
11 Smoke Det Reset
8 Over-current
9 Box Tamper
10 Siren Tamper
26 Fire Trouble
1 Mains Failure
2 Low Battery
Note: Faults on outputs are restored after a valid PIN is entered at the keypad.

Configuring features

You can configure testing and reporting features for the NX-320-I power module. The following
example enables a battery test which lasts for 60 minutes and sends a report to the central station
when a low battery condition occurs.
1. Navigate with the
and press OK.
2. Scroll to Battery Test>Enabled and press OK.
3. The keypad beeps once to accept the change and returns to Battery Test.
4. Scroll to Battery Test Time and press OK.
5. Select 60 min. and press OK. The keypad beeps once to confirm the change and returns to
Battery Test Time.
7. Scroll to Reports>Low Battery>Yes and press OK.
8. The keypad beeps once to accept the change and returns to Low Battery.
# Event
Arm/disarm
21 Armed
22 Disarmed
23 Ready to Arm
18 Entry
19 Exit
20 Entry or Exit
24 Not Ready to Arm
Sirens
12 Burglary Siren
13 Fire Siren
14 Any Siren
15 Fire Sir Steady
16 Any Sir Temporal
keys to NX-320-I Power Modules>Power Module 84>Feature Select
NX-10 Expander Installation Guide
# Event
Misc
32 Code Entry
7 Program Mode
0 Always On
Keypads
29 Keypad Fire
30 Keypad Medical
31 Keypad Panic
28 Keypad Beeping
27 Chime
Communications
4 Listen-in
5 Line Seizure
6 Phone Line Fault
65