GE NX-10 Installation Manual page 27

Reserved.
5.
Reserved.
6.
Reserved.
7.
Reserved.
8.
Segment 4 Reader partition:
"On" if reader is in Partition 1. (Default is "On").
1.
"On" if reader is in Partition 2. (Default is "On").
2.
"On" if reader is in Partition 3. (Default is "On").
3.
"On" if reader is in Partition 4. (Default is "On").
4.
LOCATION 243 Programming the Zones (2 segments of numerical data)
Segment 1 Door Shunt Zone
Program the zone that will be monitored as a door for access control. This location must be
programmed with a valid zone for monitored access control functions to work properly. (Default is 0)
Note: Additionally, this zone must be configured in the control panel as an "access control" zone by
programming an unused Zone Type characteristic in locations 111-169 (Seg 4, Opt 4).
Segment 2 Request To Exit (RTE) Zone
Program the zone that will be monitored to signal an RTE. If this segment is programmed with a
valid zone and the zone is faulted, the reader will activate its onboard open collector output and send
the RTE. (Default is 0)
Note: Additionally, this zone must be configured in the control panel as an RTE zone by programming an
unused Zone Type characteristic in locations 111-169 (Seg 4, Opt 3).
LOCATION 244 Programming the Various Reader Timers (4 segment of numerical data)
Segment 1 Scan Time
Enter the amount of time required to hold a card between beeps to activate the functions programmed
in Location 0, Segments 2 and 3. This timer is timed in 1/100-second increments from 0 to 2.55
seconds. (Default is 100 = 1 second).
Segment 2 Relay Active Time
Enter the amount of time the onboard open collector output is energized once activated. This timer is
timed in 1-second increments from 0 to 255 seconds. (Default is 10 = 10 seconds).
NX-10 Expander Installation Guide
27