Nx-534E Programming Worksheets - GE NX-10 Installation Manual

Segment 1 – Module number (default = 0)
Location 5, segment 1 contains the X-10 module number. Program a number from 0-15 to represent
the corresponding X-10 module number from the following table.
Module 1 2
Segm. 1 0 1
Segment 2 – House code (default = 0)
Location 5, segment 2 contains the X-10 house code. Program a number 0-15 to represent the
corresponding X-10 house code from the following table.
X-10
ADDRESS
CODES
LOCATION 6-13 - PROGRAMMING X-10 ADDRESS FOR OUTPUTS 2-9 (2 segments, numerical
data)
Locations 6 through 13 are used to program the X-10 address for outputs 2-9. Each location has 2
segments. Segment 1 contains the module number and segment 2 contains the house code. Refer to
the instructions in location 5, as well as the charts shown above and the programming worksheets.

NX-534E Programming worksheets

(Defaults are in bold italic text)
LOC
0 OPTION FLAGS (Circle numbers to program)
1 OFF: Line hold mode. ON: Call-back mode
2 OFF: Normal two-way. ON: Listen-in only
3 OFF: Automatic speaker lockout. ON: Speaker lockout disabled
4 Microphone A condition at start-up
5 Microphone B condition at start-up
6 ON: Call-in feature answering machine defeat enabled
7 ON: Enable levels 7 & 8
8 Reserved
1 CALL-BACK ACCESS CODE
10 = *, 11 = #, 12 = none, 13 thru 15 = any digit
2 LINE HOLD DIGIT
10 = *, 11 = #, 12 = none, 13 thru 15 = any digit
3 TIMING OPTIONS
1 Line hold timeout (10-255 seconds)
2 New trip hang-up time (1-255 seconds)
3 Call-back window (1-255 minutes)
4 Maximum number of digits during code entry (2-255)
3 4 5 6 7
2 3 4 5 6
0 = A 4 = E
1 = B 5 = F
2 = C 6 = G
3 = D 7 = H
DESCRIPTION
8 9 10 11 12
7 8 9 10 11
8 = I
9 = J
10 = K
11 = L
DEFAULT
1 2 3 4 5 6
13 14 15 16
12 13 14 15
12 = M
13 = N
14 = O
15 = P
PROGRAMMING DATA
15 (F)
60
20
5
12