Appendix 2 Installing The Modules; Large Polycarbonate Housing - GE NX-10 Installation Manual

Appendix 2

Large polycarbonate housing

Figure 19. Opening the box and installing NX-10 in a large polycarbonate housing.
Unscrew the holding screw in the polycarbonate housing.
1.
Open the box.
2.
Lift off the lid of the box.
3.
Flip up the PCB mounting tray.
4.
If you are using a NX-534E and a NX-535:
Connect the NetworX bus cables to the NX-534E listen-in module (DATA, POS, and
5.
COM contacts).
Plug-in the 5-pin audio cable connector to the audio tap on the NX-534E listen-in
6.
module.
Remove the sticky pads and insert the pillars for the NX-534E listen-in module in the
7.
box.
Connect the NX-534E listen-in module to the box.
8.
Installing the modules