GE NX-10 Installation Manual page 52

4
5
6
7
8
Segment 3
1
2
3
4
5
6
7
8
"Send Code Entry" function: By choosing the function, "Code Entry", the reader sends a function to the control panel
along with user number and authority that says such and such user entered a code. Scanning a card then
acts just like a user entering their code on a keypad.
Location 1 Set the X-10 Address for the Badge Functions (5 segments of numerical data)
Segment 1
Unit 1 2 3
Seg 1 0 1 2
Segment 2
X-10 ADDRESS CODES
0=A
1=B
2=C
3=D
Segment 3
Function no.
0
1
2
3
Disarm
Activate Aux/KeyFob Function 1 (see control panel events)
Activate Aux/KeyFob Function 2 (see control panel events)
Broadcast an X-10 function (see Location 1)
Send a Request to Exit (RTE) and activate the relay output. (Default is On.) Location 3,
Segment 2 must be programmed with a valid zone number for the RTE to be sent.
Triple Badge Function
Send Code Entry function to the control panel
Arm Away
Arm Stay mode
Disarm
Activate Aux/KeyFob Function 1 (see control panel events)
Activate Aux/KeyFob Function 2 (see control panel events)
Broadcast an X-10 function (see Location 241)
Send a Request to Exit (RTE) and activate the relay output. (Default is On.) Location 3,
Segment 2 must be programmed with a valid zone number for the RTE to be sent.
Program a number from 0-15 to represent the corresponding X-10 Unit Code
from the following table. (Default is 0)
4 5 6 7 8
3 4 5 6 7
Program a number from 0-15 to represent the corresponding X-10 House code
from the following table. (Default is 0)
4=E 8=I
5=F 9=J
6=G 10=K
7=H 11=L
Single Badge Function. Program the X-10 function that is performed when a card
is badged once. This location only needs to be programmed if Location 0,
Segment 1, Option 7 is set. (Default is 2.)
Function performed
All units off
All lights on
On
Off
9 10 11 12 13
8 9 10 11 12
12=M
13=N
14=O
15=P
14 15 16
13 14 15