Programming The Locations For The Nx-535; Recording / Playback Messages - GE NX-10 Installation Manual

Location Term
11.6 Version
11.7 Reset Settings

Programming the locations for the NX-535

Recording / Playback messages

LOCATION 0 – Recording / playback selector (3 segments, numerical data)
Segment 1 – Recording / Playback selector
Segment 1 contains the selector whether you want to record, playback or cancel the operation.
Programming any value other than 0, 1 or 2 will be ignored.
Selectors:
0 Cancel the operation
1 Recording mode
2 Playback mode
Segment 2 – Event message selector
Segment 2 contains the individual event message selector. Herewith you can select the message you
want to record/playback. The leader message allows you to indicate who is calling, in this case the
alarm panel. The event message(s) will be followed with an address message to identify the premise
that is reporting the event (alarm). You can record up to 15 event (alarm) messages. The event
message can be "kissed-off" by means of a DTMF tone from the telephone set.
Selectors:
0 Record / Playback leader message
1 Record / Playback 1
2 Record / Playback 2
... .............................................
15 Record / Playback 15
16 Record / Playback kiss-off message
17 Record / Playback address message
18 Reserved
While in record or play mode the user should only exit system programming mode when finished
recording/playing mode.
Definition
A menu option that displays the current software version of the
selected module.
A menu option that defaults the selected module to factory
defaults.
st event message
event message
nd
event message
th