GE NX-10 Installation Manual page 25

LOCATIONS 1 - 240 Reserved
LOCATION 241 Programming the X-10 Address for the Scan Functions (5 segments of
numerical data)
Segment 1
Program a number from 0 -15 to represent the corresponding X-10 Unit Code from the following
table.
Default is 0.
Module
Seg 1
Segment 2
Program a number from 0-15 to represent the corresponding X-10 House code from the following
table. Default is 0.
X-10 ADDRESS CODES
0=A
1=B
2=C
3=D
Segment 3 Single Scan Function (Single Beep)
Program the X-10 function that is performed when a card is scanned (one beep). This location only
needs to be programmed if Location 0, Segment 1, Option 7 is set. Use the following table. Default is
2.
Function #
0
1
2
3
Segment 4 Double Scan Function (Double Beep)
Program the X-10 function that is performed when a card is scanned twice within the 2 Scan Hold
Time {two beeps}. Location 244, Segment 1 programs the length of time between beeps. The
descriptions of the function codes are the same as for Single Beep Scan Function. This location only
1 2 3 4 5 6
0 1 2 3 4 5
Function
performed
All units off
All lights on
On
Off
NX-10 Expander Installation Guide
7 8 9 10 11
6 7 8 9 10
4=E 8=I
5=F 9=J
6=G 10=K
7=H 11=L
Function #
4
5
6
All others
12 13 14 15 16
11 12 13 14 15
12=M
13=N
14=O
15=P
Function
performed
Dim
Bright
All lights off
Reserved
25