Programming The Locations For The Nx-534E - GE NX-10 Installation Manual

119
NX-10 Expander Installation Guide

Programming the locations for the NX-534E

LOCATION 0 - PROGRAMMING FEATURES (8 segments, numerical data)
Segment 1 - Line hold mode or callback mode (default = line hold mode)
This option determines if the NX-534E will operate in the line hold or callback mode when a listen-in
trigger is received. If it is programmed "OFF", the NX-534E will not release the line after any
communication, which causes a listen-in session to be triggered. The listen-in session will start
immediately. If this option is programmed "ON", the NX-534E will release the line and wait for the
central station to call it back before starting a listen-in session. Default is "OFF", line hold mode.
Segment 2 - Normal two-way or listen-in only (default = normal two-way)
This feature determines if the NX-534E will operate in the normal two-way mode or listen-in only
mode. The listen-in only mode will allow the central station to listen to the activity at the premise. If
this option is programmed "OFF", the NX-534E will function in the normal two-way mode, and
allows the central station to communicate with the person(s) at the premise. The procedure is
controlled from the central station by use of keypresses on a touch tone telephone. When an alarm
occurs during a two-way session, the session timer is set (refer to location 3, segment 2). If this
option is programmed "ON", the listen-in only mode will be functioning.
Segment 3 - Speaker lockout condition (default = off)
This feature is used to determine the speaker lockout condition. When this option is "OFF" the
automatic speaker lockout is enabled. If this feature is "ON", the speaker lockout will be disabled
(refer to feature definitions on page 4).
Segment 4 - Microphone "A" start-up selection (default = ON)
This option is used to determine if microphone "A" will be active when the session is started.
Enabling this feature will turn on microphone "A" at start-up. At default, this feature is enabled.
Segment 5 - Microphone "B" start-up selection (default = ON)
This option is used to determine if microphone "B" will be active when the session is started.
Enabling this feature will turn on microphone "B" at start-up. At default, this feature is enabled.
Segment 6 - Call in feature answering machine defeat enabled (default = OFF)
This feature will enable the answering machine defeat. When a call-in is made, at least one ring must
be received. The line is picked up and the NX-534E is listening for the PIN to be entered within the
20-second time limit. If the answering machine defeat is enabled, even if someone picks up the
phone, the NX-534E is still looking for the code. If this feature is not enabled, the NX-534E will wait
for the number of rings programmed in location 4, segment 4.
Segment 7 – Enable control levels 7 and 8 (default = OFF)
This feature will enable level 7 – status check and level 8 – arming/disarming partition 1.
Segment 8 - Reserved