GE NX-10 Installation Manual page 143

Location
14.2.2.1.2 Events
14.2.2.1.2.1 Arm/Disarm/Alarm
14.2.2.1.2.1.1 Alarms and Restores
14.2.2.1.2.1.2 Opening/Closing
14.2.2.1.2.1.3 Zone Bypass and Restores
14.2.2.1.2.2 Tamper/Fault
14.2.2.1.2.2.1 Tampers
14.2.2.1.2.2.2 Zone Trouble and Restores
14.2.2.1.2.2.3 Expander Trouble and Restores
14.2.2.1.2.2.4 Siren/Line Cut and Restores
14.2.2.1.2.2.5 RF Sensor Lost and Restores
14.2.2.1.2.2.6 RF Low Battery and Restores
14.2.2.1.2.3 Power
14.2.2.1.2.3.1 Power Trouble and Restores
Term
A menu entry that contains all configurable events for each
receiver or email account. All partitions are enabled by
default. Enabled events are formatted into one or more
messages according to pre-configured settings and sent to
the selected report destination or email address.
Select the partition(s) to include for each event report. If the
partition is not selected, no event from that partition
reports via the network regardless of what is programmed
elsewhere.
A menu entry that groups the events that are reported to
the selected email account.
A menu option that sends a report to the selected email
account when an alarm occurs and when the alarm has
been restored.
A menu option that sends a report to the selected email
account stating when the system is opened (disarmed) and
closed (armed).
A menu option that sends a report to the selected email
account when a zone is bypassed. A report is also sent
when the zone is restored (un-bypassed).
A menu entry that groups the tamper and fault events that
are reported to the selected email account.
A menu option that sends a report to the selected email
account when a tamper occurs.
A menu option that sends a report to the selected email
account when a zone fault condition occurs. A report is
also sent when the fault condition is no longer active.
A menu option that sends an expander fault and restore
report to the selected email account.
A menu option that sends a report to the selected email
account when a siren or phone fault occurs. A restore
report is sent when the fault is fixed.
A menu option that sends a report to the selected email
account when an RF sensor is missing. A restore report is
sent to the central station when the receiver receives a
valid signal from the lost transmitter.
A menu option that sends a report to the selected email
account when a low battery condition occurs in an RF
sensor. A restore report is also sent when the low battery
condition is no longer active.
A menu entry that groups the power events that are
reported to the selected email account.
A menu option that reports power failure, power restore,
low battery and low battery restore events to the selected
email account.
NX-10 Expander Installation Guide
Definition
143