GE NX-10 Installation Manual page 44

Figure 6. LED indications
(red)
(green)
(red)
(green)
Zone 1 .. 8
(green)
Notes:
•
During a fire alarm, the Fire LED is ON and the NX-1750 ProxPad buzzer sounds. Badging any
valid card silences the buzzer. To clear the Fire LED indication, badge and hold the card in
front of the reader. After the fourth beep, the Fire LED is cleared.
•
When the communication with the control panel fails, the Fire LED flashes. Typically this is
caused by a fault in the databus wiring, e.g. loose databus wire.
•
When service is required (e.g. a system trouble condition exists), all four top LEDs flashes
ON/OFF once every 2.5 seconds.
ICON / LED
ON
OFF
Flashing
ON
OFF
Flashing
ON
OFF
Flashing
ON
OFF
Flashing
ON
OFF
Flashing slow
Flashing fast
DESCRIPTION
System armed
System not armed
System in alarm
System Ready to arm
System Not Ready to arm
System Ready to Force arm
Fire alarm
Normal
Fire trouble
Mains and battery ok
Mains trouble
Battery trouble
Zone bypassed
Normal
Zone in alarm / Zone open
Zone tamper