Setting - Sharp AR-BC260 Service Manual

5. Setting

A. Key operator program
Level 1
PRINTER SETTINGS
For information on the following settings, see the indicated manuals.
General settings/copy settings
Network scanner settings
(1) Printer setting
a. Default settings
These programs are used to adjust the settings of various printer
functions.
1) Prohibit notice page printing
This program is used to disable notice page printing.
Turn on this program when you do not want the machine to print
the notice page explained.
2) Prohibit test page printing
This program is used to disable test page printing.
When the program is turned on, the PRINTER TEST PAGE in the
user settings cannot be printed.
3) A4/letter size auto change
If this program is set, and printing onto A4 size paper is selected
but not available, the printer will automatically substitute 8-1/2" x
11" size paper in place of A4 paper if 8-1/2" x 11" paper is
available.
∗ A4 paper cannot be automatically selected in place of 8-1/2" x
11".
NOTE: When A4 size is specified for a document attached to an
E-mail that has been transmitted from a foreign country
and 8-1/2" x 11" size paper is not installed in the printer,
printing cannot be done without operator intervention. If
this program is set, printing will be executed without inter-
vention if a paper tray is loaded with 8-1/2" x 11" paper.
Level 2
DEFAULT SETTINGS
INTERFACE SETTINGS
NETWORK SETTINGS
COLOR ADJUSTMENTS
INITIALIZE AND/OR STORE SETTINGS
KEY OPERATOR'S GUIDE
OPERATION MANUAL (for network scanner)
4) Delete the print hold data
Use this program to manually delete all stored data from the hard
disk.
When you touch this key, a message will appear to confirm that
you want to delete the data. Check the message and then proceed
with the deletion. If you are using the job retention function,
exercise caution when using this program.
5) Output method when memory is full
When the internal memory becomes full with printer data, further
printing is not possible, thus the print data stored to that point is
printed. This program is used to set the condition for printing. The
factory default setting is "1 SET".
6) Default paper type for bypass tray
This program is used to set the default paper type for paper
loaded in the bypass tray in printer mode.
"NONE" (a default paper type is not selected), "PLAIN", "HEAVY
PAPER", or ''TRANSPARENCY" can be selected. If "HEAVY
PAPER" is selected, select "HEAVY PAPER 1" or "HEAVY
PAPER 2". If "TRANSPARENCY" is selected, select "SPEED
MODE" or "QUALITY MODE".
The factory default setting is "NONE".
6) Job queuing
This program is used to allow new print jobs to be received while a
print job is in progress. Normally the program is enabled so that
new print jobs can be received.
If the checkmark is removed from the [JOB QUEUING] checkbox,
new print jobs are not received while a print job is in progress.
Enable or disable this program to suit your needs.
AR-BC260 PRINTER CONTROLLER SECTION 14 - 9
Level 3
PROHIBIT NOTICE PAGE PRINTING
PROHIBIT TEST PAGE PRINTING
A4/LETTER SIZE AUTO CHANGE
DELETE THE PRINT HOLD DATA
OUTPUT METHOD WHEN MEMORY IS FULL
DEFAULT PAPER TYPE FOR BYPASS TRAY
JOB QUEUING
PORT SWITCHING METHOD
ENABLE PARALLEL PORT
ENABLE USB PORT
ENABLE NETWORK PORT
I/O TIMEOUT
IP ADDRESS SETTING
ENABLE TCP/IP
ENABLE NetWare
ENABLE NetBEUI
RESET THE NIC
AUTO COLOR CALIBRATION
RESTORE FACTORY DEFAULTS
STORE CURRENT CONFIGURATION
RESTORE CONFIGURATION