Sharp AR-BC260 Service Manual page 209

66 -17
Purpose Operation test/check
Function Used to select the DTFM signal (1 – 9, 0, *, #) to
(Purpose) send it to the line and the speaker (at the max.
level). (When the FAX is installed.)
Section FAX
Item Operation
Operation/ 1. Select the DTFM signal (1 – 9, 0, *, #) to be sent.
Procedure 2. Press the [EXECUTE] key.
66 -18
Purpose Operation test/check
Function Used to select the DTFM signal (1 – 9, 0, *, #) to
(Purpose) send it to the line and the speaker (Level: soft SW
setting). (When the FAX is installed.)
Section FAX
Item Operation
Operation/ 1. Select the DTFM signal (1 – 9, 0, *, #) to be sent.
Procedure 2. Press the [EXECUTE] key.
66 -19
Purpose Backup
Function Used to write the ICU PWB SRAM contents (various
(Purpose) set values and user data) into the Flash ROM (AR-
MM9). (When the FAX is installed.)
Section FAX
Item Data
Operation/ 1. Press the [EXECUTE] key. (YES/NO key
Procedure display)
2. Press [Yes] key to write the ICU PWB SRAM
data into the Flash ROM (AR-MM9).
This function is enabled only when the AR-MM9 is installed. It is
used when the ICU PWB SRAM data must be backed up in case
of repair of the ICU PWB, etc.
66 -20
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
This function is enabled only when the AR-MM9 is installed. It is
used to restore the backup data of the AR-MM9 to the ICU PWB
SRAM after completion of repair of the ICU PWB.
66 -21
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
(Printable data)
REGISTERED
MANAGEMENT
FILE MANAGEMENT
SYSTEM ERROR
PROTOCOL
66 -22
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
AR-BC260 SIMULATION 9 - 71
Backup
Used to write the Flash ROM (AR-MM9) contents
(SRAM contents written with SIM 66-19) into the ICU
PWB SRAM. (When the FAX is installed.)
FAX
Data
1. Press the [EXECUTE] key. (YES/NO key
display)
2. Press [Yes] key to write the Flash ROM (AR-
MM9) data into the ICU PWB SRAM.
Check
Used to print various registration information,
communication, file management, system error, and
protocol information. (When the FAX is installed.)
FAX
Data
1. Select items to be printed.
2. Press the [EXECUTE] key.
Various registration information
Communication management
information
File management information
System error information
Protocol information
Setting
Used to set the sound volume of the handset.
(When the FAX is installed.)
FAX
Operation
1. Select the sound volume. (MIN: Minimum,
MIDDLE: Middle, MAX. Maximum)
2. Press the [EXECUTE] key.