Setting Up The Unit; Setup Procedure - Sharp AL-1217D Operation Manual

2
Follow the installation procedure below to use the unit properly.

SETUP PROCEDURE

When using the unit for the first time, setup the unit following the procedure shown below.
1 Open the package, and make sure that all the accessories are
supplied with the unit. (p.8)
2 Remove the protective materials. (p.9)
3 Install the TD cartridge. (p.10)
4 Load the paper in the paper tray (p.15) or the multi-bypass
tray*
5 Insert the attached power cord into the power cord socket at the
rear of the unit.
6 Connect the power cord. (p.12)
7 Install the software.*
8 Connect the interface cable*
9 Now, you can copy (p.46), print (p.33), or scan (p.35) your
document.
1
* The multi-bypass tray is only included with the AL-1457D and AL-1555.
2
* If you are only using the unit for copying, skip this step.
Downloaded from:

SETTING UP THE UNIT

If the unit does not function properly during setup or use, or if a function
cannot be used, see "TROUBLESHOOTING THE UNIT" (p.61).
1
. (p.17)
http://www.usersmanualguide.com/
2
(p.19)
2
(p.45) and turn on the unit. (p.12)
2
7