Sharp AR-BC260 Service Manual page 213

67 -11
Purpose Setting
Function Used to set the printer parallel I/F SELECT IN
(Purpose) signal.
Section Printer
Item Operation
Operation/ Enter the set value with the 10-key, and press the
Procedure [OK] key.
When a trouble occurs in communication between
PC and the printer by use of the printer parallel I/F,
change the setup content of this simulation.
Display Content
A SELECT-IN Centro I/F SELECT IN
(0:OFF 1:ON) signal YES/NO setting
67 -14
Purpose Version up
Function Used to perform version up of the firmware. (Printer)
(Purpose)
Section Firmware (Printer)
Item Operation
Operation/ 1. When the machine enters the simulation mode, it
Procedure enters the printer firmware version up mode at
the same time.
2. Use "fcopy" command on the PC side to download the
firmware file.
When the firmware data are normally downloaded and written into
the Flash ROM, "COMPLETE" is displayed.
In case of an error, the following message is displayed.
∗
When the Flash ROM kind is improper:
"ROM KIND ERROR" is displayed.
∗
When an error occurs during initializing the Flash ROM:
"FLASH ERROR" is displayed.
∗
When an error occurs during verifying:
"UPDATE ERROR" is displayed.
67
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
Set range Default
0 – 1 1
67
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
67
Purpose
Function
(Purpose)
Operation/
Procedure
1. Press [EXECUTE] key. (A3 or 11" x 17" paper is automatically
selected.)
The color patch image (adjustment pattern) is printed out.
2. Set the color patch image (adjustment pattern) printed in
procedure 1) on the document table.
3. Press [FACTORY] key on the operation panel, and press
[EXECUTE] key.
The printer color balance adjustment (step 1) is automatically
performed and the color balance check patch image is printed
out.
4. Press [REPEAT] key.
5. Press the [EXECUTE] key.
The color patch image (adjustment pattern) is printed out.
AR-BC260 SIMULATION 9 - 75
-17
Data clear
Used to clear NVRAM. (Printer)
Printer
Others
1. Press the [EXECUTE] key.
The confirmation message to clear is displayed.
2. Select YES/NO to clear the NVRAM.
YES: Clear
NO: Not clear
When the printer NVRAM is normally cleared,
"COMPLETE" is displayed. In case of an error,
"ERROR" is displayed.
-18
Data clear
Used to clear the Flash data. (Printer)
Printer
Others
1. Press the [EXECUTE] key.
The confirmation message to clear the Flash
data is displayed.
2. Select YES/NO to clear the Flash data.
YES: Clear
NO: Not clear
When the printer Flash data are normally cleared,
"COMPLETE" is displayed. In case of an error,
"ERROR" is displayed.
-24
Adjustment
Used to adjust half-tone density of the printer engine
automatically.
1. Select a color to be set.
2. Select an item to be set.