Sharp AR-BC260 Service Manual page 150

Code
Function (Purpose)
Main Sub
66 29 Used to clear the data related to the
address book (one-touch
registration, program registration/
expansion, interface memory box
registration, each table contents).
(When the FAX is installed.)
30 Used to check the status change of
the TEL/LIU sensor. (When the FAX
is installed.)
31 Used to set ON/OFF of each port for
output to the TEL/LIU. (When the
FAX is installed.)
32 Used to check (compare) the
received data (fixed data) from the
line to make judgment of error or
normal. (When the FAX is installed.)
33 Used to detect signals (BUSY TONE/
CNG/CED/FNET) from the line.
(When the FAX is installed.)
34 Used to display the time required for
sending the test image data. (When
the FAX is installed.)
35 Used to rewrite the Modem program.
(When the FAX is installed.)
36 Used to check send/receive (data/
command line) from the Modem
controller to the MFP controller.
(When the FAX is installed)
39 Used to set the destination of the
FAX. (When the FAX is installed.)
42 PIC program rewriting
(When the FAX is installed.)
43 PIC adjustment value writing
(When the FAX is installed.)
60 ACR data registration
67 1 Used to check the operations of
printer DRAM read/write.
11 Used to set the printer parallel I/F
SELECT IN signal.
14 Used to perform version up of the
firmware. (Printer)
17 Used to clear NVRAM. (Printer)
18 Used to clear the Flash data.
(Printer)
24 Used to adjust half-tone density of
the printer engine automatically.
25 Printer engine color balance manual
correction: PG print (Used to perform
a fine adjustment of color from the
adjustment of SIM 67-24. )
26 Used to select the target value of the
referenced scanner in the printer
engine automatic density adjustment.
(The target value set with SIM 67-24
and the gray balance can be
adjusted.)
Used to display and register the
27
scanner target value (for
servicing) of the printer engine
automatic density adjustment.
(Conforms to the service button
of SIM 67-24. (The serviceman
can scan the target value.))
28 Used to reset the scanner target
value (for servicing) in the printer
engine automatic density adjustment
to the standard value. (Reset to the
standard value of SIM67-27.
(The value is reset to the factory
setting.))
29 Used to set the printer screen mode. Setting
40 Used to copy the scanner
destination. (Flash writing)
Purpose
Data clear FAX
Operation test/check FAX
Setting FAX
Operation test/check FAX
Operation test/check FAX
Operation test/check FAX
Setting FAX
Operation test/check FAX
Setting FAX
Setting FAX
Setting FAX
Setting FAX
Operation test/check Printer
Setting Printer
Version up Firmware (Printer)
Data clear Printer
Data clear Printer
Adjustment
Adjustment
Adjustment
Adjustment
Adjustment
Setting Flash ROM (Scanner)
AR-BC260 SIMULATION 9 - 12
Section
Data
Operation
Operation
Operation
Operation
Operation
Data
Operation
Specifications
Operation
Operation
Operation
Operation
Operation
Operation
Others
Others
Data
Item
Initializing
Writing
Writing