Figure 62: Returning To The Privileged Exec Mode; Figure 63: Saving The Priority Values With The Write Command - Allied Telesis AT-x510-28GTX Installation Manual

awplus(config)# exit
awplus#
Figure 62. Returning to the Privileged Exec Mode
4. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 63.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 63. Saving the Priority Values with the WRITE Command
5. To end the management session, enter the EXIT command.
6. Go to Chapter 8, "Cabling the Networking Ports" on page 113, to
continue with the installation.
x510 Series Installation Guide for Stand-alone Switches
109