Switch Id Led; Figure 13: Switch Id Led; Table 9: Stacking Slot Leds - Allied Telesis AT-x510-28GTX Installation Manual

Switch ID LED

LED State
Link/Activity Off
Solid green
Flashing
green
The Switch ID LED, shown in Figure 13, displays the ID number of the
switch. A stand-alone switch has the ID number 0. Switches in a VCStack
have the numbers 1 to 4. Chapter 7, "Powering On the Stack" on page 101
has the procedure for verifying and, if necessary, changing the ID number
of the switch.
The states of the LED when the switch is not operating in the low power
mode are shown in Figure 14 on page 42.
x510 Series Installation Guide for Virtual Chassis Stacks
Table 9. Stacking Slot LEDs
The slot is empty, the stacking transceiver
has not established a link to a network
device, or the LEDs are turned off. To turn
on the LEDs, use the eco-friendly button.
The stacking transceiver has established
a link at 10 Gbps to another switch in the
stack.
The stacking transceiver is receiving or
transmitting packets.
Figure 13. Switch ID LED
Description
Switch ID LED
41