Installing The Switches On A Table Or Desktop - Allied Telesis AT-x510-28GTX Installation Manual

Chapter 4: Installing the Switches on a Table or in an Equipment Rack

Installing the Switches on a Table or Desktop

72
This section contains the procedure for installing the switch on a table.
Note
The rubber feet on the bottom of the chassis should be left on for
table installation.
Warning
Do not stack switches on top of one another on a table because that
could present a personal safety hazard if you need to move or
replace units.
To install the chassis on a table, perform the following procedure:
1. Review the procedure in "Choosing a Site for the Switches" on
page 66 to verify that the selected site is suitable for the unit.
2. Check to be sure that the table is strong enough to support the weight
of the switch.
3. Lift the chassis onto the table.
4. Check to be sure that all of the appropriate components are included
in the shipping container. Refer to "Unpacking the Switch" on page 69.
Warning
Do not stack switches on top of one another on a table or desktop
because that could present a personal safety hazard if you need to
move or replace switches.
After placing the switches on the table or desktop, go to Chapter 5,
"Verifying the Status of VCStack" on page 85 to verify that VCStack is
activated on the units.