Installing The Switch In An Equipment Rack; Figure 23: Turning The Switch Upside Down; Figure 24: Removing The Rubber Feet - Allied Telesis AT-x510-28GTX Installation Manual

Installing the Switch in an Equipment Rack

This procedure requires the following items:
Eight bracket screws (included with the switch)

Two equipment rack brackets (included with the switch)

Flat-head screwdriver (not provided)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)

Installation guidelines may be found in "Choosing a Site for the Switches"
on page 66. Here is the procedure for installing the switch in a 19-inch
equipment rack.
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.
1. Place the unit upside down on a level, secure surface.
Figure 23. Turning the Switch Upside Down
2. Using a flat-head screwdriver, pry the rubber feet from the bottom of
the switch, as shown in Figure 24.
Figure 24. Removing the Rubber Feet
x510 Series Installation Guide for Virtual Chassis Stacks
E28

73