Figure 45: Activating Vcstack With The Stack Enable Command; Figure 46: Returning To The Privileged Exec Mode With The Exit Command; Figure 47: Saving The Change With The Write Command; Figure 48: Rebooting The Switch With The Reboot Command - Allied Telesis AT-x510-28GTX Installation Manual

3. Enter the STACK ENABLE command to activate VCStack on the
switch, as shown in Figure 45:
awplus(config)# stack enable
% The device needs to be restarted for this change to take effect.
awplus(config)#
Figure 45. Activating VCStack with the STACK ENABLE Command
4. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 46.
awplus(config)# exit
awplus#
Figure 46. Returning to the Privileged Exec Mode with the EXIT Command
5. Enter the WRITE command to save your change, as shown in
Figure 47.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 47. Saving the Change with the WRITE Command
Note
If this is the initial management session of the switch, the WRITE
command automatically creates in flash memory a new configuration
file called DEFAULT.CFG in which it stores your configuration
change. You may change the name of the file or designate a
different file after you create the stack.
6. Restart the switch with the REBOOT command, as shown in
Figure 48.
awplus# reboot
reboot system? (y/n):
awplus#
Figure 48. Rebooting the Switch with the REBOOT Command
7. Type "Y" for yes.
8. Wait one minute for the switch to initialize its management software.
x510 Series Installation Guide for Virtual Chassis Stacks
89