Christie CP2210 User Manual page 136

Appendix A: Serial API Commands
Link Decrypter Installed (LDI)
Access Level: Advanced
Min Power Level: Power Down
Set LD to installed or not installed.
SUBCODE DESCRIPTION OF USE
Set to 1 to installed and 0 to not installed.
None
EXAMPLES:
(LDI 1) Set LD installed.
Lamp Intensity Calibration (LEN)
Define model and serial number for primary installed lens and auxiliary lens.
SUBCODE DESCRIPTION OF USE
Auxiliary lens model
AMOD
Auxiliary lens serial number
ASER
Main lens model
MMOD
Main lens serial number
MSER
Not available
NONE
EXAMPLES:
(LEN+MMOD?L) List supported lens model
(LEN+AMOD?L) List supported auxiliary lens model
(LEN+MMOD 1 Set lens model
(LEN+MSER "xxxx") Set lens serial number
Lens Horizontal Position Adjustment (LHO)
Adjust lens offset to specific horizontal position with a specified direction. NOTE: This command can only be
used to update the current ILS file. Changing the horizontal offset for the current channel will change the horizon-
tal offset for any channel using the same ILS file.
Use command without subcode:
•
If ILS is ON, motor will move to specified steps and save data to the active channel.
• If ILS is OFF, motor will move to specified steps, do not save data to the active channel.
SUBCODE DESCRIPTION OF USE
Motor backlash in negative direction. Read-only.
BACN
Motor backlash in positive direction. Read-only.
BACP
Calibrate travel range and backlash on specified. Only valid parameter for this command is 1. Set only command.
CALB
Replace xxx with the channel number. Valid range is 101-164.
Cxxx
Moving lens mount to a specified horizontal position with a specified direction.
NONE
Motor moving range in negative direction. Read-only.
RNGN
Motor moving range in positive direction. Read-only.
RNGP
Move motor to the center flag then move back to current position. Only valid parameter for this command is 1. Set only command
RSET
Start motor moving in specified direction, where direction can be (-1, 1). Write-only for v1.3 or newer.
STRT
Stops the motor. Write-only for v1.3 or newer.
STOP
Moves the motor a given number of steps based on the current location. Write-only for v1.3 or newer.
MOVR
A-10
Downloaded from ProjectorsManual.com Manuals
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)