Replace The Air Filter - Christie CP2210 User Manual

7.10 Replace the Air Filter

without the filter installed. Always discard used air filters.
You should check the condition of the light engine air filter monthly. Replace the light engine air filter when
you replace the lamp module or sooner if you are operating the projector in a dusty or dirty environment. The
filter is located on the right side of the projector behind the air filter cover.
1. Loosen the 2 captive screws on the bottom of the
filter cover. (Figure 7-4)
2. Pull the cover out and down.
3. Slide the air filter out and discard. Insert the new
air filter with the airflow indicator facing toward
the projector. NOTE: Never reuse an old air filter.
The air filters in this product cannot be cleaned
thoroughly enough for reuse and can lead to the
contamination of optical components.
4. Install the air filter cover by inserting the 2 bottom
tabs and then snapping the door closed.
5. Tighten the 2 captive screws.
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
Downloaded from ProjectorsManual.com Manuals
Use only high efficiency Christie approved filters. Never operate the projector
Section 7: Maintenance
Figure 7-4 Remove Light Engine Air Filter
7-7