Mount Touch Panel Controller (Tpc) - Christie CP2210 User Manual
Dlp digital cinema projector
Hide thumbs
Also See for CP2210:
- User manual (164 pages) ,
- Service manual (146 pages) ,
- Setup manual (58 pages)
Table of Contents
Advertisement
Section 2: Installation and Setup
2.5
Mount Touch Panel Controller (TPC)
The TPC comes pre-assembled with the base and mounting arm. If you have a TPC-660E check the main
switch on the back of the TPC. Ensure it is connected properly.
1. Loosen the mounting arm enough for the end to fit over the ball joint located on the rear panel of the
projector (Figure 2-3).
2. Tighten the mounting arm until it fits snug on the ball joint (Figure 2-4).
3. Connect the cable from the TPC to the connector located on the projector rear panel.
4. Adjust the angle of the TPC.
2-6
Downloaded from ProjectorsManual.com Manuals
Figure 2-3 Loosen Mounting Arm
Figure 2-4 Tighten Mounting Arm
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
Advertisement
Table of Contents
