Christie CP2210 User Manual page 141

MOVR
EXAMPLES:
(LVO 500 1) Move lens to position 500 along vertical axis with positive approach
(LVO 500 -1) Move lens to position 500 along vertical axis with negative approach
(LVO+C101 -500 1) Set lens vertical position for channel 1 to -500 with positive approach
(LVO ?) Return current motor position along vertical axis and direction
(LVO+CALB 1) Calibrate the vertical axis
(LVO+RSET 1) Reset the vertical axis
(LVO+STRT 1) Starts motor moving in positive direction
(LVO+STOP) Stops motor
(LVO+MOVR -100) Move motor 100 steps in negative direction
(LVO+MOVR 200) Move motor 200 steps in positive direction
Measured Color (MCG)
Select the Measured Color Gamut file. This file describes the native colorimetry for the projector as installed and is
required for accurate color processing in the cinema electronics. This control is per channel to allow for different
colorimetry for applications such as 3D.
SUBCODE
Cxxx
NONE
EXAMPLES:
(MCG+C108 "Nominal") Use file "Nominal" on channel 108
(MCG+C108?) Get measured color file name on channel 108
(MCG?L) List all entries of measured color control
Channel Name (NAM)
Set the descriptive channel name for the specified channel
SUBCODE
Cxxx
NONE
EXAMPLES:
(NAM+C108 "Scope 2.39") Set channel name for channel 108
(NAM+C108?) Get channel name for channel 108
Network Setup (NET)
Set the network parameters for Eth0, Gateway, and Subnet 0.
SUBCODE
DLP0
ETH0
GATE
HOST
MAC0
SUB0
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
Downloaded from ProjectorsManual.com Manuals
Moves the motor a given number of steps based on the current location. Write-only for v1.3 or newer.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Select measured color gamut for the current channel.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Select channel name for the current channel.
DESCRIPTION OF USE
Set the IP address for the MGMT Ethernet controller (deprecated).
Set the WAN IP address for the projector
Set the WAN Gateway for the projector
Host name
Gets the MAC address of the projector
Set the WAN subnet mask for the projector
Appendix A: Serial API Commands
A-15