Connect A Computer Or Server; Connecting Devices To The Scci Port - Christie CP2210 User Manual

Section 3: Connecting Devices to the Projector
3.2

Connect a Computer or Server

To communicate with the projector from a computer, server or an existing network, connect the equipment to
the Ethernet hub or switch.
3.3

Connecting Devices to the SCCI Port

The Simple Contact Closure Port (SCCI) port is a DB-9 (male) connector is located on the PIB input panel and
is used to control a limited set of projector functionality through contact closures. This table lists the control
functions available through the SCCI:
Table 3.1 SCCI Connector Pinouts
PIN
1
2
3
4
5
6
7
3-2
Downloaded from ProjectorsManual.com Manuals
Figure 3-3 Connecting Communications
SIGNAL NAME
+5V Standby
Lamp ON
+5V Standby
Lamp OFF
+5V Standby
Douser Closed
Douser Open
DIRECTION DESCRIPTION
Out Current limited 5VDC supply
In Projector at Power On mode, lamp is
ON
Out Current limited 5VDC supply
In Projector at full power, lamp is OFF
Out Current limited 5VDC supply
In Close douser
In Douser open
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)