Ddic Card; Connect Devices To The 3D Sync Ports; Connect A Computer Or Server - Christie D4K2560 User Manual

DDIC Card

The following table shows the video quadrant mappings for the DDIC Four-Port input configuration:
Four-Port Input Configuration
Slot 1 1-Dual Link DVI-I
Slot 2 1-Dual Link DVI-I
Slot 3 1-Dual Link DVI-I
Slot 4 1-Dual Link DVI-I

Connect Devices to the 3D Sync Ports

The 3D Sync Input and Output ports located on the MCPU faceplate provide a convenient method for
interfacing the projector to the 3D stereo projection system. The 3D Sync Input should be connected
to the 3D video source for synchronization of the left eye/right eye frames. The 3D Sync Output is
available for control of an IR Emitter for active glasses or a polarization device for passive glasses.

Connect a Computer or Server

To communicate with a remote computer, server or an existing network, use an RJ-45 cable to
connect the Ethernet hub or switch to the Ethernet port, located on the projector MCPU faceplate.
When using the Christie serial protocol over Ethernet, connect to port 3002.
For applications or equipment utilizing serial communications, use the Christie-proprietary serial
protocol to communicate with the RS-422 port or the RS-232 ports on the MCPU faceplate.
The RS-232 port located on the MCPU faceplate utilizes Christie-proprietary protocol and is
intended for Christie accessories or automation controllers only. Failure to comply may result
in equipment damage.
D4K2560/ Mirage 4K25 User Manual
020-101076-02 Rev. 1 (11-2013)
Top left
Top right
Bottom left
Bottom right
Connect Devices
27