Table of Contents
Advertisement
Dual Link DVI Input
PWR
Select a video source
After connecting a video source to the projector, you must select it using the touch panel controller
(TPC).
1. On the TPC, select Input > Channel.
2. Scroll the list of channels until you find the channel that best matches your configuration.
3. Tap the channel.
An image appears on the screen. If an image does not appear on the screen, repeat steps 1 to
3, selecting a different channel.
Connect a computer or server
To communicate with a remote computer, server or an existing network, use an RJ-45 cable to
connect the Ethernet hub or switch to the Ethernet port, located on the projector MCPU faceplate.
When using the Christie serial protocol over Ethernet, connect to port 3002.
For applications or equipment using serial communications, use the Christie-proprietary serial
protocol to communicate with the RS422 port or the RS232 ports on the MCPU faceplate.
Notice. Failure to comply with the following may result in property damage.
The RS232 port located on the MCPU faceplate uses Christie-proprietary protocol and is intended for
Christie accessories or automation controllers only. For more information on the serial commands,
see the
D4K-60 Serial API Commands Technical Reference (P/N:
Set up Ethernet
Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network. To
modify IP settings, or manually enter an address.
D4K3560 Setup Guide
020-101161-05 Rev. 1 (06-2015)
Analog
1 - Dual Link DVI-I
Digital
Connect Devices
Signal
2 - VGA
020-101258-XX).
31
Advertisement
Table of Contents
