S.bus/S.bus2 Installation - FUTABA T10J Manual

S.BUS/S.BUS2 INSTALLATION

This set uses the S.BUS/S.BUS2 system. The wiring is as simplified and clean mounting as
possible, even with models that use a large number of servos. In addition, the wings can be
quickly installed to the fuselage without any extraneous wiring by the use of only one simple
wire, even when there are a large number of servos used.
●When using S.BUS/S.BUS2, special settings and mixes in your transmitter may be unnecessary.
●The S.BUS/S.BUS2 servos memorize the number of channels themselves. (Settable with the T10J)
●The S.BUS/S.BUS2 system and conventional system (receiver conventional CH used) can be mixed.
S.BUS Glider usage example
* i Connector makes S.BUS
connection of SVi servo to receiver.
S.BUS Aerobatic plane usage example
HUB×1 (Optional)
i-i Connector (Optional)
i Connector (Optional)
i-i Connector (Optional)
Receiver: R3008SB
Servo: S3173SVi×9 (Optional)
i-i Connector (Optional)
* i-i Connector makes S.BUS connection
of SVi servo to SVi servo.
Throttle servo: BLS173SV ( Optional )
Battery: FR2F1800 ( Optional )
Switch: HSW-L
Receiver: R3008SB
Aileron servo: BLS174SV×2 ( Optional )
HUB×3 ( Optional )
Rudder Servo: BLS175SV×1 ( Optional )
Elevator servo: BLS173SVi×2 ( Optional )
33