Acceleration
Acceleration setting can be performed at Elevator,
Elevator → Camber and Aileron → Rudder. (Glider
only)
● This setting is divided into elevator setting and camber
setting. The setting method is the same.
● Camber setting sets the acceleration function for Ele
to camber mixing. Setting is not performed when Ele to
camber mixing is INH.
● The acceleration function can be set for both the up
side and down side.
● Function ON/OFF switch setting is performed for
Aileron→ Rudder setting only.
● Aileron→ Rudder setting is acceleration
function setting for Aileron→ Rudder mixing. It is not
performed when Aileron→ Rudder mixing is INH.
● Select [Acceleration] at the model
menu and call the setup screen shown
below.
When using this
function, Tap [INH].
(ON is displayed.)
●Return to Model menu
The rate the angle
increases.
Setting method
● Acceleration rate setting (Rate)
● The return time after operation (Damping)
can be set.
● T h e o p e r a t i o n p o i n t a t a c c e l e r a t i o n
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
[Corresponding model type]: Airplane/glider general
Condition group/
single mode selection
(Gr. /Sngl)
The return time after operation (Damping)
can be set.
(First return)1 ~ 100(Slow return)
(Acceleration doesn't function as 0.)
149
To next page
2/3 : Elevator → Camber
3/3 : Aileron → Rudder
Note: When using the acceleration function,
since the servo stroke is large, make your
settings so there is no binding of your linkage.
→
GO to TABLE OF CONTENTS
Operation up to this
range will initiate
acceleration.
Act position
Current position