Telemetry:rpmSensor - FUTABA T16IZ Manual

Telemetry : RPM Sensor
The RPM Sensor screen is used to set up an
optional rpm sensor and display the rotation
information it transmits.
The rotation of the model (engine, motor, etc.)
which is flying can be shown.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
● Tap the [ rpm sensor] button in the Telemetry screen
to call the setup screen shown below.
●Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
will show that an alarm
will sound when the
rpm rises above the set
value.
↓ A downward arrow
will show that an alarm
will sound when the
rpm falls below the set
value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Alarm set : Over (Under) rotations
1. Tap Alarm and choose from Buzzer, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if not using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [xxx rpm] item.
4. Adjust the rate using the "▼▼" "▼" "▲" "▲▲"
buttons.
Initial value: ↑ 2,000 rpm ↓ 0 rpm
Adjustment range: 0 rpm~150,000 rpm
(↑Limit ≧ ↓Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
*An rpm sensor must be installed in the aircraft.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
"Magnet" SBS-01RM →
"Optics" SBS-01RO →
"Brushless motor" SBS-01RB →
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
98
→
Displaying data from the rpm
rpm
Sets the rpm on which
the alarm operates.
Gear ratio 1.00~99.00
Blade 2~10
Pole 2~30
GO to TABLE OF CONTENTS