Telemetry:rpm - FUTABA T10J Manual

R.P.M : Display of SBS-01RM/RO(Option), and alarm setup
RPM is a screen which displays / sets up the
RPM information from an optional RPM sensor.
The RPM of the model (engine, motor, etc.)
which is flying can be shown.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
●Select [RPM] in the TELEMETRY screen
and access the setup screen shown
below by press the Jog key.
●UP: Indicates that the
alarm will start when
the RPM rises above
the set value.
●DN: Indicates that the
alarm will start when
the RPM falls below
the set value.
● Y o u c a n h e a r t h e
RPM data through an
earphone or headset,
by Activating the Speech
function.
Alert set : Over rotations
1. Move the cursor to the UP:ALERT item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT) [value]item.
4. Ajust the rate by press the +-key.
Initial value: 2000rpm
Adjustment range: 0rpm~390,000rpm
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
76
*A RPM sensor must be installed in the aircraft.
R.P.M
MAX=
(ALARM) (VIB)
UP▶INH ▶OFF
DN▶INH ▶OFF
TYPE▶ OPT. FIN▶
SPEECH▶ INH SW▶ NULL
●"MAG.(MAGNETIC)" or "OPT.
(OPTICAL)" is set according
to the sensor you use.
SBS-01RM : MAGNETIC
SBS-01RO : OPTICAL
● T h e m a x i m u m w h e n
powering ON are shown.
● RPM
● M a x i m u m
pressing the Jog key for 1
second.
0 rpm
0 rpm
If the following types are selected, the
(LIMIT)
transmitter will vibrate during the warning.
▶ 0
▶ 0
TYPE 1
0
TYPE 2
TYPE 3
●In "OPTICAL", the number of
blades("FIN") of the propeller ( r o
t o r ) your model is entered.
●In "MAGNETIC", the gear ratio
of your engine (motor) you are
using is entered.
● Switch selection
OFF OFF
OFF
ON
ON
2 Position 3 Position
Alert set : Under rotations
1. Move the cursor to the DN:ALERT item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT) [value]item.
4. Ajust the rate by press the +-key.
Initial value: 0rpm
Adjustment range: 0rpm~390,000rpm
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
dat e r e s e t b y
"VIB" type