Advertisement
CARF-Models P-47
www.carf-models.com
You may choose to prime and paint the firewall. This is optional and not required
Servo Tray
Locate the Throttle Servo Hardware pack. The throttle servo tray is built as shown using thick
CA, epoxy or aliphatic resin glue. The blind nuts are pressed into place and should also be
secured with a small amount of glue so they cannot back out. The throttle servo tray is bolted to
the back of the firewall using the provided bolts and washers. The mounting holes are already
located on the back of the firewall, but must be drilled all the way through. The following photos
show the sequence of steps:
72
Advertisement
