Advertisement
CARF-Models P-47
www.carf-models.com
The engine dome is prepped for gluing; apply 30 minute epoxy to the plywood backing plate.
Use the engine, blind nuts and mounting bolts to clamp everything in place and set aside. NOTE:
it is a good idea to apply some epoxy to the blind nuts so they cannot come loose. AVOID getting
epoxy on the screw threads!
Once set, remove the engine from the dome; locate the four remaining bolts, washers and blind
nuts. Apply a small amount of epoxy to each blind nut and access the 4 pre-drilled holes from the
backside of the firewall. Bolt the dome in place, securely embedding the blind nuts in the
plywood and allow epoxy to set.
69
Advertisement
